Zavio D520E Guia de Instalação Página 1

Mac OS using Safari Browser Change light environment setting The default setting of lighting environment is 60Hz. However,

Change the Web Interface into your preferred language Use the settings screen to set the language of the Web Interface. Go to “Setting → Basic → Sys

7. The IP Camera will send you a message with its Public IP and Private IP if the IP Notification Option is enabled. 8. Click on the sma

Access to the Internet a. Internet connectivity of the IP camera can be established by inputting the cameras IP information within the Information se

c. Internet Connectivity of the IP Camera can be established if your router is UPnP (Universal Plug and Play) enabled. The IP camera is automatica

Memo ………………………………………………………………………………….. ………………………………………………………………………………….. ………………………………………………………………………………….. ………………………………………………………………………………….. ……………………

Memo ………………………………………………………………………………….. ………………………………………………………………………………….. ………………………………………………………………………………….. ………………………………………………………………………………….. ……………………

Memo ………………………………………………………………………………….. ………………………………………………………………………………….. ………………………………………………………………………………….. ………………………………………………………………………………….. ……………………

Zavio D520E Quick Installation Guide Please follow the installation steps below to set up your D520E IP Camera. Check the package contents against

Physical overview Rugged dome Dome cover Cable gland plug Cable gland Claw Thread-lock sealing nut Conduit hole Reset button

Install the hardware and connect all cables a. Installer the hardware 1. Loosen the tamper-proof screws using supplied special hex wrench and remove

b.Wall mounting and Ceiling mounting Ceiling 1. Paste the drill template on the Wall or Ceiling which rugged d

c. Mounting with Bracket (Optional) 1. Route network and power cables through wall and allow extending. 2. Loosen the two bol

d. Connect all cables b1. Power over Ethernet (PoE) 1. Using a standard RJ-45 network cable, connect the IP Camera to a P

Microsoft OS: Use the software CD to install Intelligent IP Installer Power on your PC and insert the CD-ROM. The setup page will show up automatical

3. Enter your Username and Password to login to the IP Camera. (Default is admin / admin) 4.